Users Online Now:
Donate To GLP
Back to Forum
Back to Thread
REPLY TO THREAD
chainsaw repair help wanted
Ms Sans Serif
In accordance with industry accepted best practices we ask that users limit their copy / paste of copyrighted material to the relevant portions of the article you wish to discuss and no more than 50% of the source material, provide a link back to the original article and provide your original comments / criticism in your post with the article.
[quote:Anonymous Coward 23093962:MV8yMDE2Nzk0XzMzODg5NTE0X0RERkNDRg==] [quote:Anonymous Coward 25476330:MV8yMDE2Nzk0XzMzODg5NDg5X0FFNkM1MTBD] Hi if the jets in the carb are blocked a quick fix is to remove the air filter start the saw then block the air inlet this will force fuel through the carb and clean it out. Another trick is to spray WD40 into the air inlet then start the saw. I got so pissed off with little 2 stroke engines I bought a gen with a 250cc single 4 stroke engine and electric tools. [/quote] Oh so you have a generator and use an electric weed wacker? Never thought of that but I don't like extension cords when I'm doing that stuff. [/quote]
hi i have a homelight 46 cc chainsaw yes its a cheapie
i dont normally mess with these tiny motors but thought i have another go and have ended up frustrated as usual.
my question is about the carbs on these things. it is a carb
problem initially it would not start and run no matter what
without ether own the throat so i disasemble an cleane the carb because there was a very good chance of old fuel and
now i can get it to run with 3/4 choke but it shuts down
when the choke is removed.
i think i got the jets cleaned but could not work out how to
remove from the carb body is there some rubber gasket pump?
that could be causing this
and is this just a throw away job?
Pictures (click to insert)
Big Round Smilies
Aliens and Space
Friendship & Love
Misc Small Smilies
View All Categories
Next Page >>
Disclaimer / Copyright Info
with questions or comments about this site.
"Godlike Productions" & "GLP" are registered trademarks of Zero Point Ltd. Godlike™
Website Design Copyright © 1999 - 2017 Godlikeproductions.com
Page generated in 0.007s (5 queries)