Users Online Now:
Donate To GLP
Back to Forum
Back to Thread
REPLY TO THREAD
chainsaw repair help wanted
Ms Sans Serif
In accordance with industry accepted best practices we ask that users limit their copy / paste of copyrighted material to the relevant portions of the article you wish to discuss and no more than 50% of the source material, provide a link back to the original article and provide your original comments / criticism in your post with the article.
[quote:Cheshire~Cat:MV8yMDE2Nzk0XzMzODkyOTY3XzM1RUU2QzY3] [quote:Anonymous Coward 25276568:MV8yMDE2Nzk0XzMzODkyOTM1X0E2OTdGOTBF] [quote:Cheshire~Cat:MV8yMDE2Nzk0XzMzODkyNjQ4XzlDM0I1NDQ5] [quote:Anonymous Coward 25541851:MV8yMDE2Nzk0XzMzODg5ODY4XzRFRjJCNTcw] [quote:Cheshire~Cat:MV8yMDE2Nzk0XzMzODg5NzczX0NCNjcxQTg0] Check the gas line...it's probably cracked somewhere. You have to change it every couple years anyway. [b]You really should be cutting wood in early spring btw[/b]. [/quote] how come? is it due to the sap being down for green wood? what im cutting is recyled fencing from a ranch its long dried out [/quote] Yeah pretty much. Wood needs a good 6-9 months to season. [/quote] I have burned hundreds of cord worth of green/wet wood. The trick is to stack the wood around your stove so the heat will dry it out. Helps bring up the indoor humidity a bit too. Of course it is best to let it dry and season, but its not entirely necessary. [/quote] Depends on how much room you have too. I've just had better luck seasoning it. To each their own :) [/quote]
hi i have a homelight 46 cc chainsaw yes its a cheapie
i dont normally mess with these tiny motors but thought i have another go and have ended up frustrated as usual.
my question is about the carbs on these things. it is a carb
problem initially it would not start and run no matter what
without ether own the throat so i disasemble an cleane the carb because there was a very good chance of old fuel and
now i can get it to run with 3/4 choke but it shuts down
when the choke is removed.
i think i got the jets cleaned but could not work out how to
remove from the carb body is there some rubber gasket pump?
that could be causing this
and is this just a throw away job?
Pictures (click to insert)
Big Round Smilies
Aliens and Space
Friendship & Love
Misc Small Smilies
View All Categories
Next Page >>
Disclaimer / Copyright Info
with questions or comments about this site.
"Godlike Productions" & "GLP" are registered trademarks of Zero Point Ltd. Godlike™
Website Design Copyright © 1999 - 2017 Godlikeproductions.com
Page generated in 0.005s (5 queries)