Godlike Productions - Conspiracy Forum
Users Online Now: 1,308 (Who's On?)Visitors Today: 631,522
Pageviews Today: 1,272,100Threads Today: 777Posts Today: 14,544
11:27 PM

Back to Forum
Back to Forum
Back to Thread
Back to Thread
Message Subject How I make Colloidal Silver for personal use
Poster Handle handyHealer
Post Content
You can check your cs batch using the Tyndale effect . I have been using the same red laser pointer for years. Shine the laser through the water before you start. You should not see a light trace through the water. As the CS is being generated check with the light every 5 minutes or so. You will start to see the light scattering by particles in the colloid. The broader the light trace becomes the more concentrated the batch. You can test the effectiveness of your CS this way. I tried this the first time using a 5 gallon bucket that was sitting outside that green algae in it. After pouring one teaspoon of CS into the bucket about 20 minutes later the algae was gone and the water was very pure looking. I have been making it and using it for many years. Just a drop on my tongue lets me know when the batch is ready. I make in a gallon crock using 27 volts DC and large 99.99999 silver stripes. I start with clean pure water, electrodes 1 inch apart for 5 minutes, then 5 minutes 3 inches apart, than 5 minutes 6 inches apart. I use coffee filters to fill blue glass bottles. The healing abilities on cuts and burns is amazing.
(DISCLAIMER I am half nuts and a bit out there crazy so do not listen to anything I say)
Please verify you're human:

Reason for copyright violation: