|
REPORT COPYRIGHT VIOLATION IN REPLY
|
|
Message Subject
|
I am modding my AR, ask me a question
|
|
Poster Handle
|
Lazy_Dog |
|
Post Content
|
Well, what are you doing?
Gas 2 piston?
Upper swap/different caliber?
Tax Stamps?
My LMT is as she came.
Only thing I'm about to change, is the trigger.
It's like an 8lb pull, I'm thinking like 6lb would be better..
Quoting: Anonymous Coward 47148083 Going to a BCM BFH 16" upper with a Geissele FCG (SD-C). Not sure what I want to do with the BCG, I might just stay with the BCM BCG for awhile and see if I like it. Might change the charging handle too, thinking of the Rainer Armors Raptor for that. Get a good MP tested Nickle Boron coated BCG.. and see if you can get your upper done as well.. scrap that Geissele they are a pain in the ass.. you can get a fine trigger with standards parts. have your FCG NiB as well and throw your lube away. I put a few puffs of dry teflon on my gas rings and can fire a case of ammo with no malfs. then use a stainless brush to knock off the carbon, soak BCG in soapy boiling water dry.. lather rinse repeat. I thought about going with the NiB BCG as well. Not to concerned with the trigger, if I don't like it, I will just change it out again. I will have to look into the NiB on the BCG and FCG.
|
|
|
Please verify you're human:
|
|
|
Reason for copyright violation:
|
